General Ledger Menu
The General Ledger menu is a special menu that contains commands used to launch General Ledger programs from other modules. This menu does not actually appear in the General Ledger module; it is only available in NDS modules that interface with General Ledger.
Note: To activate the General Ledger menu in a module, you must set up the G/L Application Control for the module during installation.
Directions:
To open
the General Ledger menu from the Menu Bar of
Payroll, click General Ledger.
Keyboard shortcut: [ALT]
[g]
The table below describes the available options.
|
General Ledger Menu Items Tip: For more information about the General Ledger menus, refer to the General Ledger documentation. |
|
|
Daily Work |
Contains commands used to complete routine General Ledger tasks. Keyboard shortcut: [ALT] [g] [a] |
|
File Maintenance |
Contains commands used to maintain the major General Ledger files. Keyboard shortcut: [ALT] [g] [m] |
|
Reporting |
Contains commands used to print General Ledger Reports. Keyboard shortcut: [ALT] [g] [r] |
|
Year End |
Contains commands used to process the Year-End for the General Ledger. Keyboard shortcut: [ALT] [g] [y] |
|
Utilities |
Contains commands that are used on an infrequent basis or for a single time basis or not at all. These are special programs used for setting up the module environment and for special routines. Keyboard shortcut: [ALT] [g] [t] Tip: The Utilities menu for an outside module does not display all of the commands available from within the General Ledger module. |
|
Help |
Contains the About command to display version information about the General Ledger module. Keyboard shortcut: [ALT] [g] [h] Tip: The Help menu for an outside module does not display all of the commands available from within the General Ledger module. |